Back to Overview

Drill tail screws using tips

Jun 28,2024

The technique of using drill screws mainly includes the following points:

Preparation work:

Ensure that the right size and type of drilling screws are selected to meet the requirements.
Select a suitable screwdriver or screwdriver head and make sure it matches the notch of the drill end screw.
Butt material:

Determine the position and orientation of the two materials that need to be joined, align them and clamp them.
Start fixing:

Align the drill head of the drill screw with the joint of the two materials you want to join.
Using a screwdriver or screwdriver head, slowly insert the drill screws into the material.
You may feel some resistance as the drill screw begins to pass through the first material and into the second material. Continue to turn the screwdriver with appropriate force until the screw is fully drilled into both materials.
Using an electric drill:

For stainless steel drilling screws, special electric drill (recommended power 600W) is required.
Adjust the positioner of the electric drill to the proper position to ensure that the screw is drilled to the correct position.
Check drill speed to make sure it is within the proper range.
Select the appropriate sleeve or cross head to install on the drill, and then connect the screws.
When installing the screw and the drill must be perpendicular to the surface of the molded steel plate, and click the power switch to create a central point.
Use your hand to add about 13 kilograms of force to the drill to ensure that the force is in the same vertical line as the center point.
Turn on the power switch, can not stop halfway, and quickly stop drilling after the screw is in place to prevent drilling is not in place and excessive drilling.
Note:

Ensure that screws, drill and construction surface are kept parallel.
When drilling screws, adjust the speed of the electric drill, install the sleeve and determine the position of the electric drill positioner.
Turn on the switch of the electric drill, and close the electric drill immediately after the drilling screw is drilled into the appropriate depth of the construction surface.
Following these tips will ensure the effective use of the drill screws and the firmness of the connection.

Hot Tags:

Fastener

PREVIOUS:

Key technology of high-efficiency bolt connection of steel structure

NEXT:

Anchor bolt type and size specification table

Contact Us

E-mail:
cxy3768@jiuyaofasteners.com (Mr. Chen)
wmx7703@jiuyaofasteners.com (Mr. Wang)
wmy6240@jiuyaofasteners.com (Mr. Wang)
yc1383@jiuyaofasteners.com (Mr. Yang)

WhatsApp:
+86 13673201383

Phone/ WeChat:
+86 17531001207
+86 15188843768
+86 13673201383

Address:
9-27,28, East Industrial City, Yongnian District, Handan City, Hebei Province

Related Posts